OBD cables available for FOX3 devices

You are here:
Estimated reading time: 1 min

Connection your FOX3 unit to the OBDII connector of the vehicle is a very convenient choice as it reduces a lot the time (and money) to install the GPS tracker. In that sense, FALCOM offers a variety of OBD cables depending on the needs of each project/customer:

  • CA111B: 2×4 Micro-Fit to OBDII cable with IGN bridged to V+.
    This cable allows you to apply power to the FOX3-2G/3G/4G series and
    connect the device to the OBDII connector in the car. It has an OBDII
    connector on one end and one Micro-Fit male connector (2×4) on the other.  Because this cable has the IGN wire bridged to V+, you will
    be not able to use the IGN-sleep mode, so you have to use MOTION-sleep
    instead. Cable length: 1.5 m.
    Pinout:

    2×4 Micro-Fit OBDII connector Description
    2 5 GND
    6 6 CAN_High
    5 14 CAN_Low
    1 16 V+
    3 16 IGN (bridged to V+)
  • CA112: Y-Cable with 2×4 and 2×8 Micro-Fit connectors to OBDII with IGN
    bridged to +V.
    This cable allows you to apply power to the FOX3-2G/3G/4G series and
    connect the CAN-Bus of IOBOX-CAN with the OBDII connector in your car. It
    has an OBDII connector on one end and two Micro-Fit male connectors (2×4
    and 2×8) on the other. Because this cable has the IGN wire bridged to
    V+, you will be not able to use the IGN-sleep mode, so you have to use
    MOTION-sleep instead. Cable length: 1.5 m.
    Pinout:

    2×4 Micro-Fit 2×8 Micro-Fit OBDII connector Description
    1 16 V+
    2 5 GND
    3 16 IGN (bridged to V+)
    10 6 CAN_High
    12 14 CAN_Low
    13 7 K-Line*
    14 15 L-Line*

    * Currently not supported by the firmware.

  • CA123: 2×4 Micro-Fit to OBDII cable with IGN as separate wire.
    This cable allows you to apply power to the FOX3-2G/3G/4G series and
    connect the device to the OBDII connector in the car. This has an OBDII
    connector on one end, one Micro-Fit male connector (2×4) on the other and
    the IGN as a separate wire. With this cable you are able to use the
    IGN-sleep mode, if the IGN line is in use.
    Pinout:

    2×4 Micro-Fit OBDII connector Description
    2 5 GND
    6 6 CAN_High
    5 14 CAN_Low
    1 16 V+
    3 IGN as a separate wire
Was this article helpful?
Dislike 0 0 of 0 found this article helpful.
Views: 114
Back to Top